26
computer’s on-board video
sources.
Image appears
blurred,
indistinct, or too
Brightness is too low. Open the OSD menu and
select Brightness
the brightness scale as
Check Video
Cable is
displayed on
screen.
Monitor video cable is disconnected.
Connect the appropriate
video signal cable
monitor. Be sure that the
computer power is off
while you connect the
of Range is
displayed on
Video resolution and/or refresh rate are set
higher than what the monitor supports.
Change the settings to a
supported setting.
The monitor
does not enter
into a low-
The monitor's power saving control is disabled. Open the OSD menu and
select Power, select Auto-
Sleep Mode, and then set
“OSD Lockout”
is displayed
The monitor’s OSD lock function is enabled. Press and hold the Menu
button for 10 seconds to
disable the OSD Lockout
Locked is
Displayed
The monitor's Power Button Lockout function is
enabled.
button for 10 seconds to
unlock the power button