HP E27u G4 - HDMI connector HDMI1; DP connector DP1;DP2; USB-C connector USB1

15
HDMI connector HDMI1
Repair the HDMI connector:
1) Use a soldering iron to remove as much solder as possible from the pin.
2) Lift the HDMI connector from the PCB.
3) Place the new component on the PCB. Be sure that it matches the PCB footprint.
4) Solder the new component.
DP connector DP1/DP2
Repair the DP connector:
1) Use a soldering iron to remove as much solder as possible from the pin.
2) Lift the DP connector from the PCB.
3) Place the new component on the PCB. Be sure that it matches the PCB footprint.
4) Solder the new component.
USB-C connector USB1
Repair the USB-B connector:
1) Use a soldering iron to remove as much solder as possible from the pin.