HP E45c G5 - USB Type C 1 Connector CN1008; USB Type C 2 Connector CN504

23
USB Type C 1 connector CN1008
Repair the USB Type-c connector:
1) Use a soldering iron and a de-soldering pump to remove as much solder as possible from the pin.
2) Use a hot air gun to melt the solder on the pins.
3) Lift the CN1008 connector from the circuit board.
4) Place the new component on the circuit board. Be sure that it matches the footprint.
5) Solder the new component.
USB Type C 2 connector CN504
Repair the USB Type C connector:
1) Use a soldering iron and a de-soldering pump to remove as much solder as possible from the pin.
2) Use a hot air gun to melt the solder on the pins.