HP E45c G5 - USB 3.0 A 3;4 Connector CN1032;CN1033

25
2) Lift the CN103/CN1004 connector from the circuit board.
3) Place the new component on the circuit board. Be sure that it matches the footprint.
4) Solder the new component.
USB 3.0A 3/4 connector CN1032/CN1033
Repair the USB 3.0A 3/4
1） Use a soldering iron and a de-soldering pump to remove as much solder as possible from the pin.
2) Lift the CN1032/CN1033 connector from the circuit board.
3) Place the new component on the circuit board. Be sure that it matches the footprint.
4) Solder the new component.