Inserting and removing a SIM
CAUTION: To prevent damage to the connectors, use minimal force when inserting a SIM.
To insert a SIM, follow these steps:
1. Turn off the computer by using the Shut down command.
2. On select models, close the display.
3. Disconnect all external devices connected to the computer.
4. Unplug the power cord from the AC outlet.
5. Carefully insert a paperclip or other thin metal rod into the SIM/MicroSD memory card release
access located on the tablet. This will open the panel to the left of the release access, allowing
access to the SIM and MicroSD memory cards.
6. Insert the SIM into the SIM slot, and gently push the SIM into the slot until it is firmly seated.
NOTE: The SIM in your computer may look slightly different from the illustration in this section.
7. Replace the SIM/MicroSD slot cover.
8. Reconnect external power.
9. Reconnect external devices.
10. Turn on the computer.
To remove a SIM, press in on the SIM, and then remove it from the slot.
Using GPS (select models only)
Your computer may be equipped with a Global Positioning System (GPS) device. GPS satellites
deliver location, speed, and direction information to GPS-equipped systems.
For more information, see the HP GPS and Location software Help.
24 Chapter 3 Connecting to a network
To Next Page
Loading...
Need help?
General
Weight and Dimensions
