Table 7-5 Solid-state drive descriptions and part numbers (continued)
Description Spare part number
1 TB, for use in the PRC N77395-001
1 TB, TLC M16560-001
1 TB, TLC, NMIC N22908-001
1 TB, TLC, self-encrypting drive (SED) N23415-001
1 TB,TLC, SED, NMIC N24954-001
512 GB N45476-001
512 GB, TLC M17436-001
512 GB, TLC, SED M52031-001
512 GB, TLC, for use in the PRC N77393-001
512 GB, for use in the PRC N77392-001
256 GB N45477-001
256 GB, SED N35225-001
256 GB, for use in the PRC N77391-001
Solid-state drive support kit N96251-001
Before removing the SSD, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 62).
2. Remove the bottom cover (see Bottom cover on page 62).
3. Disconnect the battery cable from the system board (see Battery on page 74).
NOTE: The type of SSD cover differs for models with a plastic bottom cover or a metal bottom cover,
Remove the M.2 2280 SSD from models with a plastic bottom cover:
1. Remove the Phillips M2.0 × 2.5 screw (1) from the drive assembly.
2. Remove the Phillips M2.0 × 4.0 screw (2) from the drive assembly.
3. Lift the end of the drive assembly (3) up, and then pull the assembly (4) away from the socket to
remove it.
70
Chapter 7 Removal and replacement procedures for Customer Self-Repair parts
To Next Page
Loading...
