4. Remove the NFC module (4) from the computer. The module is secured with adhesive.
To install the NFC module, reverse this procedure.
Smart card reader
To remove the smart card reader, use this procedure and illustration.
Table 8-7
Smart card reader descriptions and part numbers
Descriptions Spare part numbers
Smart card reader
NOTE: The smart card reader spare part kit does not include the antenna. The antenna is included in
the touchpad spare part kit.
N96232-001
Smart card reader cable (included in Cable Kit) N96440-001
Before removing the smart card reader, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 62).
2. Remove the bottom cover (see Bottom cover on page 62).
3. Remove the battery (see Battery on page 74).
4. Remove the left speaker (see Speakers on page 76).
Remove the smart card reader:
1. Remove the four Phillips M2.0 × 2.5 screws (1) from the smart card reader bracket.
Smart card reader
81
To Next Page
Loading...
