4. Remove the speakers (4).
NOTE: When removing the speakers, make note of the location of the rubber isolators (5) in the
screw holes. The absence of or damage to these isolators can result in degraded speaker
performance.
To install the speakers, reverse this procedure.
Fingerprint reader board
To remove the fingerprint reader board, use this procedure and illustration.
Table 8-3
Fingerprint reader board descriptions and part numbers
Description Spare part number
Fingerprint reader board N96242-001
Fingerprint reader board cable (included in the Cable Kit) N96921-001
Fingerprint reader insert (included in the Plastics Kit) N96234-001
Fingerprint reader bracket N96233-001
Before removing the fingerprint reader board, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 62).
2. Remove the bottom cover (see Bottom cover on page 62).
3. Remove the battery (see Battery on page 74).
4. Remove the right speaker (see Speakers on page 76).
Remove the fingerprint reader board:
1. Disconnect the cable from the ZIF connector (1) on the fingerprint reader .
2. Remove the two Phillips M2.0 × 2.5 screws (2) that secure the fingerprint reader bracket to the
computer, and then remove the bracket (3).
Fingerprint reader board
77
To Next Page
Loading...
