4. To remove the battery latches, rotate the latches (1), and then use a tool to release the latches (2)
from the computer.
NOTE: It is not necessary to remove the battery latches during normal battery replacement. Only
replace the latches if they are missing or broken.
To install the battery, reverse the removal procedures.
NOTE: When replacing the battery, be sure to align the battery on the pins and then lock the latches.
Speakers
To remove the speakers, use this procedure and illustration.
Table 8-2
Speakers description and part number
Description Spare part number
Speakers N96451-001
Before removing the speakers, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 62).
2. Remove the bottom cover (see Bottom cover on page 62).
3. Disconnect the battery cable from the system board (see Battery on page 74).
Remove the speakers:
1. Disconnect the speaker cable from the system board connector (1).
2. Remove the four Phillips M2.0 × 2.0 screws (2) that secure the speaker to the computer.
3. Remove the cable from the clips and tape (3) between the speakers.
76
Chapter 8 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
