10. To remove the bezel:
a. Flex the top (1), the left and right sides (2), and then the bottom of the bezel (3) to release it.
b. Remove the bezel (4) from the display.
NOTE: To avoid damaging the panel, do not use a tool to release the inside of the bezel. You can
use a tool only when you insert it from the outside of the top, left, and right sides of the bezel. Use
your fingers to lift up on the bezel. Avoid pressing down on the panel during removal.
The display bezel is available as the following spare part numbers:
N96562-001: Models with an FHD camera
N96561-001: Models with an IR camera
N96564-001: Models with an IR camera and privacy display
N96563-001: Models with no camera
11. To remove the display panel:
a. The display panel is secured to the display enclosure with tape that is installed under the sides
of the panel. To remove the panel, from all four corners, use tweezers to pull the end of the
tape (1) out from behind the panel. Use tweezers or your fingers to pull the tape (2) out from
behind the display panel. You must pull the tape multiple times before it is completely removed.
b. Rotate the display panel over and place it next to the display enclosure (3).
Display panels are available as the following spare part numbers:
P06010-001: WUXGA, 300 nit panel, touch screen
P06011-001: WUXGA, 300 nit panel
P06013-001: WUXGA, 400 nit panel
P06012-001: WQXGA, 1000 nit panel
Display assembly
91
To Next Page
Loading...
