c. Remove the 2 broadhead Phillips PM2.0×2.5 screws (1) that secure each display hinge to the
display enclosure.
d. Lift the display hinges o the display enclosure (2).
9. If it is necessary to replace the WLAN antenna cables and transceivers:
WLAN and WWAN antennas are available in the Antenna Kit, spare part number 769704-001.
a. Release the WLAN antenna transceivers (1) from the clips built into the display enclosure. (The
WLAN antenna transceivers are attached to the display enclosure with double-sided tape.)
b. Detach the WLAN antenna cables from the routing channels (2) built into the display enclosure.
c. Remove the WLAN antenna cables and transceivers. The WLAN antenna cables and transceivers are
included in the Antenna Kit, spare part number 769704-001.
Component replacement procedures 71
To Next Page
Loading...
