2. Remove the Phillips M2.0 × 2.5 screw (2), and then remove the WLAN module (3).
3. If the WLAN module antenna is not connected to the terminal on the WLAN module, install a
protective sleeve on the antenna connector, as shown in the following illustration.
To install the WLAN module, reverse the removal procedures.
Speakers
To remove the speakers, use this procedure and illustration.
Table 5-5
Speakers description and part number
Description Spare part number
Speakers (include cables, left and right speakers, and 4 rubber isolators) N13695-001
Before removing the speakers, follow these steps:
Speakers
45
To Next Page
Loading...
