1. Disconnect the RTC battery cable (1) from the system board.
2. Detach the RTC battery (2) from the top cover/keyboard. (The RTC battery is attached to the top
cover/keyboard with double-sided adhesive.)
3. Remove the RTC battery.
To install the RTC battery, reverse this procedure.
NFC module cable
To remove the NFC module cable, use this procedure and illustration.
NOTE: The NFC module cable is included in the Cable Kit, spare part number N09288-001.
Before removing the NFC module cable, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 39).
2. Remove the bottom cover (see Bottom cover on page 39).
3. Remove the battery (see Battery on page 41).
Remove the NFC module cable:
1. Release the ZIF connector (1) the NFC module cable is connected to, and then disconnect the NFC
module cable from the system board.
2. Release the ZIF connector (2) the NFC module cable is connected to, and then disconnect the NFC
module cable from the NFC module.
62
Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
