2. Remove the cable retainer (2) and the I/O bracket (3) from the computer.
The cable retainer and the I/O bracket are included in the Bracket Kit, spare part number
N49522-001.
3. Remove the microSD card blank insert (1) from the microSD card slot.
4. Remove the connector board (2) from the computer.
To install the connector board, reverse this procedure.
Fan
To remove the fan, use this procedure and illustration.
Table 5-9
Fan description and part number
Description Spare part number
Fan (includes cable and captive screws) N02330-001
Before removing the fan, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 39).
2. Remove the bottom cover (see Bottom cover on page 39).
3. Disconnect the battery cable from the system board (see Battery on page 41).
50
Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
