2. Detach the NFC module (2) from the top cover with keyboard. The NFC module is attached to the
top cover with keyboard with double-sided adhesive.
3. Remove the NFC module.
To install the NFC module, reverse this procedure.
Touchpad cable
To remove the touchpad cable, use this procedure and illustration.
NOTE: The touchpad cable is included in the Cable Kit, spare part number N09288-001.
Before removing the touchpad cable, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 39).
2. Remove the bottom cover (see Bottom cover on page 39).
3. Remove the battery (see Battery on page 41).
Remove the touchpad cable:
1. Release the ZIF connector (1) the touchpad cable is connected to, and then disconnect the
touchpad cable from the system board.
2. Release the ZIF connector (2) the touchpad cable is connected to, and then disconnect the
touchpad cable from the touchpad.
64
Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
