1. Prepare the computer for disassembly (see Preparation for disassembly on page 39).
2. Remove the bottom cover (see Bottom cover on page 39).
3. Disconnect the battery cable from the system board (see Battery on page 41).
Remove the solid-state drive:
1. Remove the solid-state drive shield.
The solid-state drive shield is included in the Bracket Kit, spare part number N49522-001.
2. Remove the Phillips M2.0 × 2.5 screw (1) that secures the drive to the computer.
3. Pull the drive (2) away from the socket to remove it.
To install a solid-state drive, reverse the removal procedures.
NOTE: Solid-state drives are designed with a notch to prevent incorrect insertion.
Solid-state drive
47
To Next Page
Loading...
