Table 5-13 Fingerprint reader description and part number
Description Spare part number
Fingerprint reader
NOTE: The fingerprint reader spare part kit does not include the fingerprint reader bracket or
fingerprint reader cable. The fingerprint reader bracket is included in the Bracket Kit, spare part
number N49552-001. The fingerprint reader cable is included in the Cable Kit, spare part number
N09288-001.
N08532-001
Before removing the fingerprint reader, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 39).
2. Remove the bottom cover (see Bottom cover on page 39).
3. Remove the battery (see Battery on page 41).
4. Remove the right speaker (see Speakers on page 45).
Remove the fingerprint reader:
1. Remove the Phillips M2.0 × 2.5 broad head screw (1) that secures the fingerprint reader and bracket
to the computer.
2. Remove the fingerprint reader bracket (2).
The fingerprint reader bracket is included in the Bracket Kit, spare part number N49522-001.
3. Release the ZIF connector (3) the fingerprint reader cable is connected to, and then disconnect the
fingerprint reader cable from the system board.
4. Detach the fingerprint reader cable (4) from the computer. The fingerprint reader cable is attached
to the computer with double-sided adhesive.
5. Remove the fingerprint reader (5) and cable.
60
Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
