HP Integrity rx7640 - Figure 2-14 Attaching a Caster to the Server

Chapter 2
Installing the Server
Wheel Kit Installation
60
Step 9. Locate and remove one of the four screws from the plastic pouch. Attach the a caster to the server.
Figure 2-14Attaching a Caster to the Server
Step 10. Attach the remaining casters to the server using the screws supplied in the plastic pouch.
Step 11. Remove the foam blocks from the left and right side of the server.
Step 12. Locate the plywood ramp.
Step 13. Attach the ramp to the edge of the pallet.
NOTE There are two pre-drilled holes in the ramp. Use the two screws taped to the ramp to
attach the ramp to the pallet.
Step 14. Carefully roll the server off the pallet and down the ramp.
Step 15. Locate the caster covers.
NOTE The caster covers are designed to fit on either side of the server.