Chapter 2
Installing the Server
Installing Additional Cards and Storage
65
Removable Media Drive Installation
The DVD drive, or DAT tape drive is located in the left front of the chassis. The server power must be turned
off before installation.
Figure 2-18 Removable Media Location
Step 1. Remove the front bezel.
Step 2. Remove the filler panel from the server.
Step 3. Install the left and right media rails and clips to the drive.
Step 4. Connect the cables to the rear of the drive
Step 5. Fold the cables out of the way and slide the drive into the chassis.
The drive easily slides into the chassis; however, a slow firm pressure is needed for proper seating.
The front locking tab will latch to secure the drive in the chassis.
Step 6. Replace the front bezel.
Step 7. Power on the server, and power up nPartitions.
Step 8. Verify operation of the drive.
Removable Media
To Next Page
Loading...
