HP Integrity rx7640 - Configuring LAN Information for the MP; Figure 2-30 MP Main Menu

Chapter 2
Installing the Server
Cabling and Power Up
86
The MP Main Menu is displayed:
Figure 2-30 MP Main Menu
Configuring LAN Information for the MP
This section describes how to set and verify the server management processor (MP) LAN port information.
LAN information includes the MP network name, the MP IP address, the subnet mask, and the gatway
address. This information is provided by the customer.
To set the MP LAN IP address:
Step 1. At the MP Main Menu prompt (MP>) enter cm to enter the MP Command.
NOTE If the Command Menu is not shown, enter q to return to the MP Main Menu, then
enter cm..
Step 2. From the MP Command Menu prompt (MP:CM>) enter lc (for LAN configuration).