HP Integrity rx7640 - Accessing the Management Processor Via a Web Browser; Figure 2-32 the Ls Command Screen

Chapter 2
Installing the Server
Cabling and Power Up
88
Step 10. A screen similar to the following is displayed, allowing verification of the settings:
Figure 2-32 The ls Command Screen
Step 11. To return to the MP main menu, enter ma.
Step 12. To exit the MP, enter x at the MP main menu.
Accessing the Management Processor via a Web Browser
Web browser access is an embedded feature of the MP/SCSI card. The Web browser enables access to the
server through the LAN port on the core I/O card. MP configuration must be done from an ASCII console
connected to the Local RS232 port..
NOTE The MP/SCSI card has a separate LAN port from the system LAN port. It requires a separate
LAN drop, IP address, and networking information from that of the port used by HP-UX.
Before starting this procedure, the following information is required:
• IP address for the MP LAN
• Subnet mask
• Gateway address
• Host name (this is used when messages are logged or printed)
To configure the LAN port for a Web browser, perform the following steps:
Step 1. Connect to the MP using a serial connection.
Step 2. Configure the MP LAN. Refer to “Configuring LAN Information for the MP”.
Step 3. Type CM to enter the Command Menu.