Chapter 2
Installing the Server
Cabling and Power Up
85
On the front of the server, a solid green Power LED and a solid green MP Status LED will illuminate after
about 30 seconds. Refer to Figure 2-29.
Figure 2-29 Front Panel Display
2. Check the bulk power supply LED for each BPS.
When on, the breakers distribute power to the BPSs. AC power is present at the BPSs:
• When power is first applied. The BPS LEDs will be flashing amber.
• After 30 seconds has elapsed. The flashing amber BPS LED for each BPS becomes a flashing green
LED.
Refer to power cord policies to interpret LED indicators.
3. Log in to the MP:
a. Enter Admin at the login prompt. The login is case sensitive.
It takes a few moments for the MP prompt to display. If it does not, be sure the laptop serial device
settings are correct: 8 bits, no parity, 9600 baud, and na for both Receive and Transmit. Then, try
again.
b. Enter Admin at the password prompt. The password is case sensitive.
To Next Page
Loading...
