To Next Page

To Previous Page

# Authorize the user to use SSH, Telnet, and terminal services.

[Sysname-luser-seclog] service-type ssh telnet terminal

[Sysname-luser-seclog] quit

# According to the network plan, the user will log in to the device through SSH or telnetting, so you need

to configure the authentication mode of the VTY user interface as scheme.

[Sysname] display user-interface vty ?

INTEGER<0-15> Specify one user terminal interface

The command output indicates that the device supports sixteen VTY user interfaces, which are numbered

0 through 15.

[Sysname] user-interface vty 0 15

[Sysname-ui-vty0-15] authentication-mode scheme

[Sysname-ui-vty0-15] quit

2. Configuration performed by the security log administrator

# Re-log in to the device as user seclog.

C:/> telnet 1.1.1.1

******************************************************************************

* Without the owner's prior written consent, *

* no decompiling or reverse-engineering shall be allowed. *

******************************************************************************

Username:seclog

Password:

# Display the summary of the security log file.

<Sysname> display security-logfile summary

Security-log is enabled.

Security-log file size quota: 1MB

Security-log file directory: flash:/seclog

Alarm-threshold: 80%

Current usage: 0%

Writing frequency: 1 hour 0 min 0 sec

The command output indicates that the directory for saving the security log file is flash:/seclog.

# Change the directory where the security log file is saved to Flash:/securitylog.

<Sysname> mkdir securitylog

%Created dir flash:/securitylog.

<Sysname> info-center security-logfile switch-directory flash:/securitylog/

# Display contents of the security log file buffer.

<Sysname> display security-logfile buffer

%@175 Nov 2 17:02:53:766 2009 Sysname SHELL/4/LOGOUT:

Trap 1.3.6.1.4.1.25506.2.2.1.1.3.0.2: logout from Console

176

HP JD320B User Manual

Other manuals for HP JD320B