HP LaserJet Pro 500 - Page 107

Figure 2-1 Control-panel 2ndary Service test access buttons
Table 2-1 Control-panel 2ndary Service test access buttons
Item Description
1 Left arrow button
2
Cancel
button
1. From the Home screen on the product control panel, touch the Setup button.
2. Touch the left arrow button, and then quickly touch the Cancel
button. The display should return
to Ready status.
3. Press the Setup
button again to open the menus. The first menu should be the 2ndary Service
menu.
4. Touch the 2ndary Service menu, and then scroll to one of the following menu items.
●
LED Test
●
Display Test
●
Button Test
5. Touch the menu item to begin the test.
6. After completing the test, return the product to the Ready state, and then touch the Cancel
button to remove the 2ndary Service menu from the menu list.
ENWW
Troubleshooting process
85
draft version