The product herewith complies with the requirements of the R&TTE Directive 1999/5/EC, EMC Directive 2004/108/EC, the Low Voltage
Directive 2006/95/EC and carries the CE-Marking
accordingly.
This Device complies with Part 15 of the FCC Rules. Operation is subject to the following two Conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
1. The product was tested in a typical configuration with Hewlett-Packard Personal Computer Systems.
2. For regulatory purposes, this product is assigned a Regulatory model number. This number should not be confused with the marketing
names or the product number(s).
3. The product meets the requirements of EN55022 & CNS13438 Class A in which case the following applies: “Warning — This is a
class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take
adequate measures.”
4. Telecom approvals and standards appropriate for the target countries/regions have been applied to this product, in addition to those
listed above.
5. This product uses an analog fax accessory module which Regulatory Model numbers are: BOISB-1102-00 (US-LIU) or BOISB-1102-01
(EURO LIU), as needed to meet technical regulatory requirements for the countries/regions this product will be sold.
6. This product uses a radio module device which Regulatory Model number is SDGOB-1191 as needed to meet technical regulatory
requirements for the countries/regions this product will be sold.
Boise, Idaho USA
November 2012
For Regulatory Topics only, contact:
European Contact: Your Local Hewlett-Packard Sales and Service Office or Hewlett-Packard GmbH, HQ-TRE,
Herrenberger Straße 140, 71034 Böblingen, Germany
www.hp.eu/certificates
USA Contact: Product Regulations Manager, Hewlett-Packard Company, PO Box 15, Mail Stop 160, Boise, Idaho
83707-0015 (Phone: 208-396-6000)
ENWW
Declaration of conformity (wireless models)
227
To Next Page
Loading...
