HP M24FD - HDMI Connector P200;P300; VGA Connector P100; Type C Connector UP100

20
HDMI connector P200/P300
Repair the HDMI connector:
1) Use a soldering iron and a desoldering pump to remove as much solder as possible from the pin.
2) Use a hot air gun to melt the solder on the pins.
3) Lift the P200 or P300 connector from the PCB.
4) Place the new component on the PCB. Be sure that it matches the PCB footprint.
5) Solder the new component.
VGA connector P100
Repair the VGA connector:
6) Use a soldering iron and a de-soldering pump to remove as much solder as possible from these pin.
7) Lift the P100 connector from the PCB.
8) Place the new component on the PCB. Be sure that it matches the PCB footprint.
9) Solder the new component.
Type C connector UP100
Repair the Type C connector:
10) Use a soldering iron and a de-soldering pump to remove as much solder as possible from the pin.
11) Use a hot air gun to melt the solder on the pins.
12) Lift the UP100 connector from the PCB.