HP MSR2000 Series Preparing For Installation

3
Figure 1 Airflow through the MSR4000 chassis
To ensure good ventilation, the following requirements must be met:
 Leave at least 10 cm (3.94 in) of clearance for the air inlet and outlet vents.
 The installation site has a good cooling system.
ESD prevention
CAUTION:
Check the resistance of the ESD-preventive wrist strap for safety. The resistance readin
g
should be in the
range of 1 to 10 megohm (Mohm) between human body and the ground.
To prevent electrostatic discharge (ESD), follow these guidelines:
 Make sure the router and the floor are well grounded.
 Take dust-proof measures for the equipment room.
 Maintain the humidity and temperature at a proper level.
 Always wear an ESD-preventive wrist strap and ESD-preventive cloth when touching a circuit board
or transceiver module.
An MSR4000 router does not supply an ESD-preventive wrist wrap. Prepare an ESD-preventive
wrist wrap yourself.
 Place the removed memory module, CF card, or interface module on an antistatic workbench, with
the face upward, or put it into an antistatic bag.
 Touch only the edges, instead of electronic components when you observe or move a removed
memory module, CF card, or interface module.

HP MSR2000 Series Specifications

General

Brand	HP
Model	MSR2000 Series
Category	Network Router
Language	English