HP MSR2000 Series Preparing For Installation

5
 ESD-preventive gloves, ESD-preventive wrist wrap, and antistatic bag or mat
Installation accessories shipped with the router
 Power cord
 Console cable
 Grounding cable
 Mounting brackets
Checklist before installation
Table 4 Checklist before installation
Item Re
q
uirements Result
Installation site
Ventilation
 There is a minimum clearance of 10 cm (3.94 in)
around the inlet and outlet vents for heat
dissipation of the router chassis.
 A good ventilation system is available at the
installation site.
Temperature 0°C to 45°C (32°F to 113°F).
Relative humidity 5% to 90% (noncondensing).
Cleanness
 Dust concentration ≤ 3 × 10
4
particles/m
3
.
 No visible dust on desk within three days.
ESD prevention
 The equipment and floor are well grounded.
 The equipment room is dust-proof.
 The humidity and temperature are at a proper
level, respectively.
 Wear an ESD-preventive wrist strap and uniform
when touching a circuit board.
 Place the removed memory module, CF card, or
interface module on an antistatic workbench, with
the face upward, or put it into an antistatic bag.
 Touch only the edges, instead of electronic
components when observing or moving a removed
memory module, CF card, or interface module.
EMI prevention
 Take effective measures to protect the power
system from the power grid system.
 Separate the protection ground of the router from
the grounding device or lightning protection
grounding device as far as possible.
 Keep the router far away from radio stations, radar
and high-frequency devices working in high
current.
 Use electromagnetic shielding when necessary.

HP MSR2000 Series Specifications

General

Brand	HP
Model	MSR2000 Series
Category	Network Router
Language	English