EasyManuals Logo

HP OneLam 400 A User Manual

HP OneLam 400 A
404 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
- 18 -
EN
3 Connect the power cable to the connection socket in the laminator.
4 Connect the power plug to a power socket.
5 Switch the power switch to ON.
Î The transport rollers start to rotate.
Î The "COLD" status LED lights up GREEN
Î The laminator has been put into operation.
Before You Start
Please observe the following information to ensure continued reliable operation of the laminator.
Information on the Material
Do not laminate metallic, wet or uneven materials.
The material to be laminated, including the laminating pouch, must not be thicker than 0.5 mm.
Thin and soft materials should be laminated in laminating pouches with the largest foil thickness

If possible, do not use too many small pieces of material in one laminating pouch.

Only use foil pouches intended for lamination purposes.

Only use hot laminating pouches for "Hot laminating" operating mode.
Only use cold laminating pouches for "Cold laminating" operating mode.
Choose the size of laminating pouch according to the material to be laminated.
If laminating pouches need to be cut, only cut the laminating pouches after laminating.

Do not insert an empty laminating pouch in the infeed (rear) of the laminator.
Do not insert a laminating pouch when rolled up into the infeed (rear) of the laminator.
Do not insert a laminating pouch to one side of the infeed (rear) of the laminator.

of the laminator, which is ready to operate.
Do not pull the laminating pouch out of the output side (front) during laminating.
Please remember that hot laminated materials are permanently bonded to the laminating
pouch and cannot be separated from the foil again without possible damage.
Operating the Laminator
The following section describes how to complete hot lamination and cold lamination.
If the laminator is not used for a period of 30 minutes, the laminator enters Standby mode.
Press the "Operating mode" button to make the device operational.
1 Press the "Operating mode" button several times, if necessary, until the required type of

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP OneLam 400 A and is the answer not in the manual?

HP OneLam 400 A Specifications

General IconGeneral
BrandHP
ModelOneLam 400 A
CategoryLaminator
LanguageEnglish

Related product manuals