- 21 -
The knife blades in the cutting head are surrounded by a protective housing.
1 Pull out the selector switch (A, B) and turn it to the required cutting pattern.
Î The selector switch latches audibly into place.
Î The cutting pattern selected is set-up.
C D
1 Guide the paper/pouch between the stops and under the cutting device rail to the required
cutting position (C).
Use the positioning aids on the top of the laminator to align the material to be cut as required.
2
along the rail over the paper/pouch (D). Fix the material in place with your hand so that it does
not shift while being cut.
Î The paper/pouch has been cut as required.
To Next Page
Loading...
Need help?
General
