Optical drive cable
NOTE: The optical drive cable is included in the optical drive spare part kit. The optical drive cable
includes the optical drive connector.
Before removing the optical drive cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
Battery on page 47), and then remove the following components:
●
Optical drive (see
Optical drive on page 48)
●
Hard drive (see
Hard drive on page 51)
●
Keyboard (see
Keyboard on page 59)
●
Top cover (see
Top cover on page 62)
●
System board (see
System board on page 81)
Remove the optical drive cable:
1. Release the optical drive cable (1) from the clips and routing channel built into the base enclosure.
2. Remove the two Phillips PM2.0×7.0 screws (2) that secure optical drive connector to the
base enclosure.
3.
Remove the optical drive cable (2) from the base enclosure.
Reverse this procedure to install the optical drive cable.
Component replacement procedures
93
To Next Page
Loading...
