3.
Remove the hard drive (3).
4. Disconnect the hard drive cable (1) from the system board.
5. Release the hard drive cable (2) from the routing channel built into the base enclosure.
6. Remove the four Philllips PM2.5×5.0 screws (3) that secure the hard drive to the computer.
7. Remove the hard drive (4).
8. If it is necessary to replace the hard drive bracket or hard drive connector cable:
a.
Remove the four Phillips PM3.0×4.0 screws (1) that secure the hard drive bracket to the
hard drive.
b. Remove the hard drive bracket (2) from the hard drive.
52 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
