2. Detach the volume button board (2) from the display panel assembly. (The power button board is
attached to the display panel assembly with double-sided tape.)
3. Remove the volume button board and cable.
Reverse this procedure to install the volume button board.
Vibrator module
Description Spare part number
Vibrator module (includes cable) 741723-001
Before removing the vibrator module, follow these steps:
1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2. Disconnect the power from the tablet by unplugging the power cord from the tablet.
3. Disconnect all external devices from the tablet.
4. Remove the display enclosure (see
Display enclosure on page 38).
5. Disconnect the tablet battery cable from the system board (see
Sensor board on page 39).
Remove the vibrator module:
1. Disconnect the vibrator module cable (1) from the system board.
2. Release the vibrator module cable from the routing clips (2) built into the display panel assembly.
Tablet component replacement procedures
49
To Next Page
Loading...
