2. Disconnect the display panel cable (2) from the display panel.
Reverse this procedure to install the display panel cable.
Tablet battery
Description Spare part number
2-cell, 21-Wh, 2.86-Ah, Li-ion battery for use only in the tablet (includes cable) 722232-005
Before removing the tablet battery, follow these steps:
1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2. Disconnect the power from the tablet by unplugging the power cord from the tablet.
3. Disconnect all external devices from the tablet.
4. Remove the display enclosure (see
Display enclosure on page 38).
5. Disconnect the tablet battery cable from the system board (see
Sensor board on page 39).
6. Remove the heat sink (see
Heat sink on page 53).
WARNING! To reduce potential safety issues, use only the battery provided with the tablet, a
replacement battery provided by HP, or a compatible battery purchased from HP.
Tablet component replacement procedures
67
To Next Page
Loading...
