Power connector board
Description Spare part number
Power connector board (includes cable) 742735-001
Before removing the power connector board, follow these steps:
1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2. Disconnect the power from the tablet by unplugging the power cord from the tablet.
3. Disconnect all external devices from the tablet.
4. Remove the display enclosure (see
Display enclosure on page 38).
5. Disconnect the tablet battery cable from the system board (see
Sensor board on page 39).
6. Remove the bezel (see
Bezel on page 57).
Remove the power connector board:
1. Disconnect the power connector board cable (1) from the system board.
2. Remove the two Phillips PM1.85×3.35 screws (2) that secure the power connector board to the
display panel assembly.
60 Chapter 5 Removal and replacement procedures
To Next Page
Loading...
