3. Release the vibrator module (3) from the mold built into the display panel assembly.
4. Remove the vibrator module and cable.
Reverse this procedure to install the vibrator module.
RTC battery
Description Spare part number
RTC battery (includes cable and double-sided adhesive) 741724-001
Before removing the RTC battery, follow these steps:
1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2. Disconnect the power from the tablet by unplugging the power cord from the tablet.
3. Disconnect all external devices from the tablet.
4. Remove the display enclosure (see
Display enclosure on page 38).
5. Disconnect the tablet battery cable from the system board (see
Sensor board on page 39).
Remove the RTC battery:
1. Disconnect the RTC battery cable (1) from the system board.
50 Chapter 5 Removal and replacement procedures
To Next Page
Loading...
