TouchPad
Description Spare part number
For use only on HP Pro x2 410 G1 PC keyboard bases 759689-001
For use only on HP Pavilion 11 x2 PC keyboard bases 740190-001
Before removing the TouchPad, follow these steps:
1. Turn off the tablet and keyboard base. If you are unsure whether the tablet and keyboard base are
off or in Hibernation, turn the tablet on, and then shut it down through the operating system.
2. Disconnect the power from the tablet and keyboard base by unplugging the power cord from the
tablet and keyboard base.
3. Disconnect the tablet from the keyboard base.
4. Remove the bottom cover (see
Bottom cover on page 69).
5. Remove the keyboard base battery (see
Keyboard base battery on page 71).
Remove the TouchPad:
1. Release the ZIF connector (1) to which the TouchPad cable is attached, and then disconnect the
TouchPad cable from the docking board.
2. Detach the TouchPad cable (2) from the keyboard/top cover. (The TouchPad cable is attached to
the keyboard/top cover with double-sided adhesive.)
3. Remove the two Phillips PM1.85×2.75 broad head screws (3) that secure the TouchPad to the
keyboard/top cover.
Keyboard base component replacement procedures
73
To Next Page
Loading...
