Before removing the bezel, follow these steps:
1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2. Disconnect the power from the tablet by unplugging the power cord from the tablet.
3. Disconnect all external devices from the tablet.
4. Remove the display enclosure (see
Display enclosure on page 38).
5. Disconnect the tablet battery cable from the system board (see
Sensor board on page 39).
Remove the bezel:
1. Remove the eight Phillips PM1.85×4.50 screws (1) and the Phillips PM1.85×5.65 screw (2) that
secure the bezel to the display panel assembly.
2. Remove the bezel (3).
Reverse this procedure to install the bezel.
58 Chapter 5 Removal and replacement procedures
To Next Page
Loading...
