Description Spare part number
Equipped with an Intel Celeron N2920 1.86-GHz (SC turbo up to 2.00-GHz) processor (1066-
MHz FSB, 2.0-MB L2 cache, quad core, 4.5 W) , 2-GB of system memory, and the FreeDOS or
Linux operating system
754649-001
Equipped with an Intel Celeron N2910 processor (1066-MHz FSB, quad core, 4.5 W), 4-GB
of system memory, and the Windows 8 Professional operating system
741030-601
Equipped with an Intel Celeron N2910 processor (1066-MHz FSB, quad core, 4.5 W), 4-GB
of system memory, and the Windows 8 Standard operating system
741030-501
Equipped with an Intel Celeron N2910 processor (1066-MHz FSB, quad core, 4.5 W), 4-GB
of system memory, and the FreeDOS or Linux operating system
741030-001
Equipped with an Intel Celeron N2910 processor (1066-MHz FSB, quad core, 4.5 W), 2-GB
of system memory, and the Windows 8 Professional operating system
741031-601
Equipped with an Intel Celeron N2910 processor (1066-MHz FSB, quad core, 4.5 W), 2-GB
of system memory, and the Windows 8 Standard operating system
741031-501
Equipped with an Intel Celeron N2910 processor (1066-MHz FSB, quad core, 4.5 W), 2-GB
of system memory, and the FreeDOS or Linux operating system
741031-001
Before removing the system board, follow these steps:
1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2. Disconnect the power from the tablet by unplugging the power cord from the tablet.
3. Disconnect all external devices from the tablet.
4. Remove the display enclosure (see
Display enclosure on page 38).
5. Disconnect the tablet battery cable from the system board (see
Sensor board on page 39), and
then remove the following components:
a. WLAN module (see
WLAN module on page 45)
b. Solid-state drive (see
Solid-state drive on page 51)
c. Heat sink (see
Heat sink on page 53)
d. Power connector board (see
Power connector board on page 60)
Tablet component replacement procedures
63
To Next Page
Loading...
