Remove the bottom cover:
1. Remove the front (1) and rear rubber feet (2).
NOTE: The front and rear rubber feet are different shaped and sized and are available in the
Rubber Feet Kits, spare part numbers 759338-001 (for use only on HP Pro x2 410 G1 PC
keyboard bases) and 740207-001 (for use only on HP Pavilion 11 x2 PC keyboard bases).
2. Remove the six Phillips PM1.85×5.50 screws (3) and the two Phillips PM1.85×4.80 screws (4)
that secure the bottom cover to the keyboard/top cover.
3. Remove the bottom cover (5).
Reverse this procedure to install the bottom cover.
70 Chapter 5 Removal and replacement procedures
To Next Page
Loading...
