Solid-state drive
Table 5-6 Solid-state drive descriptions and part numbers
Description Spare part number
1 TB, PCle, NVMe, TLC L12805-001
512 GB, SATA-3, TLC, FIPS 140-2 L12810-001
512 GB, PCIe, NVMe, TLC L12811-001
512 GB, PCIe, NVMe, value L58065-001
256 GB, PCIe, NVMe, TLC L12807-001
256 GB, PCIe, NVMe, value L12808-001
256 GB, SATA-3, self-encrypting drive (SED), Opal 2 L12803-001
256 GB, SATA-3, TLC, FIPS 140-2 L40894-001
128 GB, SATA-3, TLC L12804-001
16 GB Optane memory module L32552-001
Before removing the solid-state drive, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 34).
2. Remove the bottom cover (see Bottom cover on page 35).
3. Remove the battery (see Battery on page 36).
Remove the solid-state drive:
▲ Remove the Phillips M2.0 × 3.0 screw (1), and then pull the solid-state drive module from the socket (2).
Reverse this procedure to install the solid-state drive.
42 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
To Next Page
Loading...
