Display assembly
Display assemblies are available as spare parts at the subcomponent level only.
Before removing the display panel, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 34).
2. Remove the following components:
a. Bottom cover (see Bottom cover on page 35)
b. Battery (see Battery on page 36)
c. Optical drive (see Optical drive on page 39)
d. Hard drive (see Hard drive on page 40)
e. Solid-state drive (see Solid-state drive on page 42)
f. WWAN module and bracket (see WWAN module on page 43)
g. Keyboard (see Keyboard on page 47)
h. Internal frame (see Internal frame on page 51)
i. Serial port board or VGA port board (see Serial port board or VGA port board on page 66).
Remove the display assembly:
1. Disconnect the wireless antenna cables from the wireless module (1).
2. Disconnect the display cable from the system board (2).
3. Remove the antenna cables from the clips in the speaker (3).
4. Rotate the display to open the hinges as far as possible, about 145° (1).
5. Remove the three Phillips M2.5 × 5.0 screws (2) from the display hinges.
76 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
