Speaker
Table 6-16 Speaker description and part number
Description Spare part number
Speaker Kit L09601-001
Before removing the speaker, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 34).
2. Remove the following components:
a. Bottom cover (see Bottom cover on page 35)
b. Battery (see Battery on page 36)
c. Optical drive (see Optical drive on page 39)
d. Hard drive (see Hard drive on page 40)
e. Solid-state drive or Optane memory module (see Solid-state drive on page 42)
f. WWAN module and bracket (see WWAN module on page 43)
g. Keyboard (see Keyboard on page 47)
h. Internal frame (see Internal frame on page 51)
i. Serial port board or VGA port board (see Serial port board or VGA port board on page 66).
j. System board (see System board on page 69)
Remove the speaker:
1. Remove the Phillips M2.5 × 3.0 screw (1) that secures the speakers to the computer.
2. Lift the speaker assembly up enough to access the antenna cables connected to it (2), and then remove
the antenna cables from the clips on the speaker assembly (3).
Reverse this procedure to install the speaker.
Component replacement procedures 73
To Next Page
Loading...
