To remove the heat sink assembly for products with discrete graphics:
1. In the order indicated on the heat sink assembly, loosen the six captive Phillips screws that secure the
assembly to the computer (1).
2. Lift the heat sink assembly from the computer (2).
3. Thoroughly clean the thermal material from the surfaces of the system board components (1)(3) and
the heat sink (2)(4) each time you remove the heat sink. Replacement thermal material is included with
the heat sink and system board spare part kits.
Reverse this procedure to install the heat sink assembly.
56 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
