To Next Page

To Previous Page

5-11

RADIUS Authentication and Accounting

Configuring the Switch for RADIUS Authentication

For example, suppose you have configured the switch as shown in figure 5-3

and you now need to make the following changes:

1. Change the encryption key for the server at 10.33.18.127 to “source0127”.

2. Add a RADIUS server with an IP address of 10.33.18.119 and a server-

specific encryption key of “source0119”.

Figure 5-3. Sample Configuration for RADIUS Server Before Changing the Key and

Adding Another Server

To make the changes listed prior to figure 5-3, you would do the following:

Figure 5-4. Sample Configuration for RADIUS Server After Changing the Key and Adding Another Server

To change the order in which the switch accesses RADIUS servers, refer to

“Changing RADIUS-Server Access Order” on page 5-30.

Changes the key

for the existing

server to

“source0127”

Adds the new

RADIUS server

with its required

“source0119” key.

Lists the switch’s

new RADIUS

server

configuration.

Compare this with

Other manuals for HP ProCurve 2810 Series

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2810 Series and is the answer not in the manual?

General