Removal and replacement procedures 56
System board configuration
Processor
HP ProLiant DL160se G6 Server supports quad core processors. If a single processor is installed,
then use socket 1. When two processors are used, the server supports boot functions through the
processor installed in socket 1. However, if processor 1 fails, the system cannot boot up, and if
processor 2 fails, the system will be automatically booted from processor 1 and provide a processor
failure message.
The processor socket supports 2P Intel Xeon processor with integrated memory controller.
CAUTION: It is recommended to use processors of the same speeds or cache sizes to prevent
possible server malfunction.
Figure 32 Processor Locations
Item Description
1 Processor 1
2 Processor 2
WARNING: To reduce the risk of personal injury from hot surfaces, allow the heat sink and the
processor to cool before touching them.
NOTE: Before installing the processor, remove the air baffle.
To Next Page
Loading...
