Removal and replacement procedures 62
Memory
The system board has twelve DIMM slots that support up to 96 GB maximum system memory (8 GB in
each of the twelve DIMM slots).
You must adhere to the following guidelines when adding or replacing memory modules:
• For 2P system, both physical processors must be of the same type and speed.
• Use 800/1066/1333 MHz DDR3 RDIMM/UDIMM.
• Installation guide for 1P configuration:
○ Follow the sequence of 2A, 4B, 6C, 1D, 3E, and 5F for the corresponding processor when
installing the memory.
• Installation guide for 2P configuration:
○ Follow the sequence of 2A, 4B, 6C, 1D, 3E, and 5F for the corresponding processor when
installing the memory.
○ Install at least one memory DIMM for each processor.
○ The memory quantity installed for each processor can be different.
Figure 40
DIMM Population
To Next Page
Loading...
