Removal and replacement procedures 84
To reinstall the hot-plug power supply:
1. Align the hot-plug power supply cage connector with the open power supply bay and slide the
power supply into the chassis.
2. Snap the latch cover over port colored handle. Latch cover only installs one way.
Figure 76
Reinstalling the Hot-plug Power Supply
Figure 77 Non-hot-plug Power Supply Unit
WARNING: Take note of the following reminders to reduce the risk of personal injury from electric
shock hazards and/or damage to the equipment.
• Installation of power supply units should be referred to individuals who are qualified to service
server systems and are trained to deal with equipment capability of generating hazardous
energy levels.
• DO not open the power supply unit. There are no serviceable parts inside it.
To Next Page
Loading...
