Remove the hot-plug fan
Procedure
1. Observe the following alert:
IMPORTANT:
After removing a high-performance (dual-rotor) fan, install or replace the fan within 60 seconds.
Otherwise, the server will shut down gracefully.
2. Do one of the following:
a. Extend the server from the rack (Extend the server from the rack on page 24).
b. Remove the server from the rack (Remove the server from the rack on page 25).
3. Remove the access panel (Remove the access panel on page 25).
4. Remove the fan.
26 Remove the hot-plug fan
To Next Page
Loading...
