11. Connect the SID cables to the front power button/USB 3.0 connector on the system board.
Installing the 4 LFF display port/USB module
Prerequisites
Before installing this option, be sure you have the following:
• The components included with the hardware option kit
• T-10 Torx screwdriver
Procedure
1. Power down the server (Power down the server on page 24).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
98 Installing the 4 LFF display port/USB module
To Next Page
Loading...
